Redundant mine shafts are becoming a growing risk for large mining houses due to a sharp spike in illegal mining activities.
The fact that the Witwatersrand Basin has been cited as contributing over 50% of all gold ever produced on earth is an indication not only of the extent of the country’s mining network, but how endemic the problem of illegal mining is to South Africa.
“The fact is that illegal mining is born from desperation. People are willing to risk their lives by going underground to try and recover pockets of unmined material, as well as copper cable and steel shaft infrastructure.
“They can be armed, which poses a huge risk. It is not uncommon to witness extreme violence or intimidation in these areas,” says Jet Demolition Contracts Manager André Botes.
The most effective means of ensuring that redundant shafts are protected from occupation by illegal miners is to seal them permanently below natural ground level (NGL), typically after filling the shaft barrel.
Here is where specialist demolition contractor Jet Demolition stands to play a vital role.
Its turnkey service offering for the mining industry includes backfilling shaft barrels, designing permanent caps, installing caps at a defined depth below NGL, and recording the final position and depth of caps, followed by the backfill and reinstatement of the natural material over cap tops.
Mining houses typically require such a turnkey service for two main scenarios:
Firstly, to seal the shaft permanently as a mitigating factor, thereby preventing unauthorised access by illegal miners or, secondly, to rehabilitate the mining footprint fully, rendering the area safe for public use.
Another challenge is that various shafts are often interconnected, such as a live shaft and a redundant shaft linking together hundreds of meters below NGL.
“It is thus critical to ensure that we understand the network we are operating within, so that our capping and sealing activities do not influence or adversely affect miners underground in a neighbouring shaft,” stresses Botes.
The main requirement for permanent shaft sealing and capping projects is to ensure full compliance with the Mine Health and Safety Act, and the provisions of the Department of Mineral Resources, the approved Environmental Management Plan, as well as any client-specific requirements.
The natural surrounding environment also has to be taken into account, paying special attention to natural water courses and stormwater management.
This could mean rerouting natural water courses slightly, while ensuring there is no subsequent negative downstream effect. All material used to fill shafts must be clean and uncontaminated.
This is vital to ensure that no groundwater contamination will occur after sealing.
“We have also sealed a few shafts that had to be equipped with monitoring access points as part of the Acid Mine Drainage (AMD) project in the Western, Central and Eastern Basins of the Witwatersrand Goldfields.
“These access points will be used to monitor the quality and volume of subsurface water in the foreseeable future,” reveals Botes.
Jet Demolition pays particular attention to health and safety, especially when working over an open shaft that could extend a few kilometres underground.
“It is absolutely critical to protect plant and personnel from falling,” maintains Botes.
Hence certified lifelines are installed prior to any work commencing, providing personnel with anchoring points during shaft sealing. Larger machines are also typically used for increased reach.